Professional Custom Paper Packaging Factory Since 2003

English

gold tissue paper gilding leather - articlesfactory.com

by:Mengsheng     2020-03-29
gold tissue paper gilding leather - articlesfactory.com
Bronzing leather is an art form that can bring hours of fun, make artwork or make exquisite gifts.Here are some tips on how to start using the right material.Bronzing leather bronzing is a thin sheet of gold or other metal alloys such as copper or silver applied to the surface.
The paper is tapped by hand or machine until they have excellent plasticity and are thinner than the thickness of the thin paper.In the past, bronzing was often used as a decoration on a book cover or photo frame and made the object look colorful.The effect of the carved leather when used in fine detail is very remarkable.
You also need to stick the leaves to the leather with adhesive or glue.This glue is called size.A commercial-Perfect work based on size.In addition, cheese or other lintFree cloth, a stiff Artist Brush leaves and some Q-The trick to remove the excess gold leaves is needed, as is a pair of squaresMove and locate the end of the gold leaf instead of the pointed tweezers.First dye the leather, and finally paint antique finishes like leather glow.
It gives a gloss and contrast that takes away the gloss of gold to some extent.Avoid solvent-Choose one specially designed for bronzing.A leather top-Finishes like super gloss can be applied to carved leather.
If this is the first time you 've tried ironing, you might want to practice on a piece of scrap leather first just to feel it.Go Slowly!Application-Gold plated areas will be obtained only after completion.Walk slowly here, be careful.If you make a mistake, wait until belowTacky finish, then gently scrape down with xacto knife.
Wait until below-The finish is completely dry before applying the size.The glue that becomes tacky varies in the length of time it takes to reach the tacky state and remain viable, and this time it is usually shown on test tubes or bottles.In gold plating for a small engraving, you may need a sticky glue for an hour and will still be available for about 20 minutes.
Use a small brush to apply glue only to the area below receivedfinish.Then check the stickiness and remember that the glue may reach this state earlier than the one shown on the bottle, depending on environmental variables such as temperature and humidity.Now is the time to apply for leaves.Wash your hands to remove any oil that may affect adhesion and carefully lift the sheets with tweezers and hands.
Do this in the draftFree room because leaves are thinner than tissuepaper.If you need to trim the sheets, put the leaves on a piece of deer skin with a dull butter knife or nail.Then pick up the sheet, apply it to the already sized area, pat it down gently with a stack of cheese cloth, then gradually increase the pressure and press the leaves on the carving.
Use the artist's brush to tie the leaves into the details of the carving.A hard brush, as wide as inches.Pay attention to the edges and make sure they are well reinforced during a good finish.You can brush off the excess leaves and save them in the jar to touchups later.
Brush along the edges until all the pieces that are not glued together are rolled away.You can now rub the gold leaves with a soft cloth to reveal the gloss and smooth any wrinkles.Once the glue is completely dry, you can rub the bronzing harder to achieve an antique look.
This will wipe away some gold leaves and reveal the size and antiques underfinish.Do not go too far, though, by rubbing only on carved Heights, on those high spots and ridges.Antique finishes can then be applied and then painted with paint or clear finish to protect the leaves from wear and stain.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...